国产黄大片在线观看,免费的黄页网址直接看,欧美精品videofree

TranslationMobile

成形壓力
緊密壓力
密實壓力

"compact" in Chinese : adj. 1.擠滿的，密集的；緊密的；(物質)致密的；( ...
"pressure" in Chinese : n. 1.壓；按；擠；榨。 2.【物理學】壓力，壓強；大 ...
"gas pressure compacting" in Chinese : 氣壓成形
"gas-pressure compacting" in Chinese : 氣壓成型
"pressure bag compacting" in Chinese : 氣袋壓實
"pressure less compacting" in Chinese : 無壓成型
"centrifugal compacting" in Chinese : 離心塑型; 離心壓壞; 離心壓坯
"coil compacting" in Chinese : 帶卷卷緊
"cold compacting" in Chinese : 常溫壓制; 冷壓
"compacting action" in Chinese : 壓實作用
"compacting by centrifuging" in Chinese : 離心塑型; 離心壓塑
"compacting by extrusion" in Chinese : 擠壓壓塑
"compacting by rolling" in Chinese : 軋壓成型; 軋壓成形
"compacting conditions" in Chinese : 壓塑條件
"compacting conveyor" in Chinese : 接取機

Examples

Compact pressure switch with display for oem applications
帶顯示的緊湊型壓力開關，用于oem應用
Compact pressure switch with display
帶有顯示的緊湊型壓力開關
The compact pressure sensors meet the electromagnetic compatibility to en 61326
緊湊型壓力傳感器滿足en 61 326的電磁兼容性emc要求。
The compact pressure sensors meet the electromagnetic compatibility acc . to en 61326
T緊湊型壓力傳感器滿足en 61 326的電磁兼容性emc要求。
Robustness and long - term stability during operation are the strengths of this compact pressure sensor for general industrial applications
對一般產業來說，堅固和穩定性強是此款緊湊型壓力傳感器的優勢。
The results showed that with 1 . 5wt % tih2 , the porosity was the maximal and above 35 / min average heating rate , the porosity clearly increased ; and along with the increasing of compact pressure , preservation time and heating temperature , the porosity would be enhanced
分析結果表明：當發泡劑tih _ 2含量為1 . 5wt時，獲得的樣品平均孔隙率最大。平均加熱速率達到35 min以上時，平均孔隙率增加顯著。隨著壓實力的增大、保溫時間的增加和樣品最終加熱溫度的升高，平均孔隙率均會增加。
The optimum conditions for air electrode preparation were shown as follows : active carbon which was baked for 15 min in 900 as carrier for catalyst , bond is 60mass % polytetrafluoroethylene ( ptfe ) liquor , 20 % ptfe in waterproof layer , 10mass % pore - making in waterproof layer thickness of waterproof layer 0 . 30mm , 10mass % ptfe in catalysis layer , nickel screen for current collector , compacting pressure 6mpa
確定制備空氣電極的最佳工藝條件為:催化劑載體的處理條件為在900下灼燒15min ,粘結劑為60mass % ptfe的水溶液。防水層中pefe含量為20mass % ,造孔劑含量為10mass % ,其厚度為0 . 3mm 。催化層中ptfe含量為10mass % 。